|
The Chairman reported on the meeting held on 23/02/2000 to discuss Lend Lease and the issue of
direct supply and read the minutes of that meeting.
He then read the notice of motion received from Bass Floor Company, which read as follows:
"We refer to the Extraordinary General Meeting held at the Parramatta Club on Wednesday 23rd
February 2000.
"We refer to the Extraodinary General Meeting held at the Parramatta Club on Wednesday 23rd
February 2000".
In accordance with the Constitution Cluase No. 43 of the FCA of NSW (amended 1993)the meeting
was invalid because;
- Written notice was not sent to all members
- Details of the proposed special resolutions were not given and;
- At least 21 days notice of the meeting was required
All resolutions passed at the above meeting to be rescined."
- Proposed: P.Kable, Bass Floor Company
- Seconded: P.Dean, Tarkett Sommer Australia
The Chairman stated that the special meeting had been called in compliance with clause 21 or the
constitution which allowed for the calling of a special General Meeting if requested by 5% of membership.
He stated that this requirement was met.
He also read Clause 17 of the Constitution outlining the Powers of the Management Committee and
stated that this requirement was met.
The Chairman then referred to Clause 43 of the Constituion and is defined of "special resolutions".
Again, he claimed that the resolutions passed at the special meeting were not in breach of this clause
of the Constituion and where therefore valid.
However, in response to the notice of motition from Bass Floor Company, he had circulated to members
notice of four motions to be put to this General Meeting. He belived all these comply with the requirements
of the Constitution.
Mr. P. Kable spoke in support of his notice of motion and asserted that 14 days notice of the meeting
should have been given to all members in writing, not by phone.
He went on to explain the events leading up to the meeting and commented that only 9 members attended
the meeting, two of which were from the same company.
The Chairman maintained that he had acted in accoradance with the Constitution and cited previous meetings
held to discuss the EBA as precedents.
Mr.B.L'Estrange proposed that the motions should be put to the meeting.
Mr.S.Kelly proposed that the resolutions passed at the special meeting on 23/2/2000 be rescinded and
the new motions be put.
Mr.P.Dean supported the Bass Floor Company's motion to rescind the resolutions passedon 23/2/2000
and stated that he thought manufacturers should have been included at that meeting.
It was moved Mr.S.Kelly, seconded Mr.P.Dean that the resolutions passed on 23/2/2000 be rescinded.
The motion was carried.
Motion 1
It was moved Mr.S.Kelly, seconded Mr.I.King that:
"FCA NSW Members do not accept invitations from Builders, Developers, Government Departments and end
users to carry out "installation Only" tenders, quotes, contracts where materials have been supplied
direct to the Builders, Developers and end users."
Mr. Irving Warren commented that there should be no inference that members could be expelled from the
Association for non-compliance, as this could be illegal.
There was some discussion on this point and it was genrerally agreed that the threat of expulsion
could not be used to enforce compliance. Consequantly, it was proposed that the words "subject to legal
advice" should be included in the motions.
Mr.S.Kelly contended tht the main concern related to the major contractors installing resilient
floorcoverings and the need to protect their industry. If the move towards direct supply is allowed
to become established, contractors will be forced to operate on a "labour only" basis.
Mr.P.Kable expressed the opinion that Lend Lease were re-thinking their position and have changed
their attitude somewhat regarding direct supply.
There was further discussion on the wording of the motion and the Chairman then read the amended
motion as follows:
FCA NSW recomends members do not accept invitations from Builders, Developers, Government Departments
and end users to carry out "installation only" tenders, quotes, contracts where materials, namely
resilient floorcovering, including timber, have been supplied direct to the Builders, Developers and end
users, (subject to legal advice).
The above motion was moved by Mr.S.Kelly, seconded by Mr.S.Brown.
The vote was taken on a show of hands, indicating:
The motion was declared carried.
Motion No.2
It was moved Mr.I.King, seconded Mr.R.Hooker that:
"FCA NSW members do not accept invitation from Buliders, Developers, Government Departments and
end users for "installation Only" tenders, quotes, contracts where materials, namely resilient
floorcoverings, including timber, have been previously supplied by Goverment Contract Suppliers in
the metropolitan supply areas (subject to legal advice).
The vote was taken on a show of hands, indicating:
29 in favour (including proxy votes)
0 against
The motion was carried.
Motion No.3
It was moved Mr.P.Kable, seconded Mr.P.Dean that:
"FCA NSW members from a sub-committee of equal contracting and manufacturing memnbers to work through
the issues of "direct supply" and "installation only". Through the government contract for Resilient Finishes
and report back to the association to the association at the next generak meeting".
Motion No.4
It was moved Mr.S.Kelly, seconded Mr.I.King that:
"This newly formed sub-committee has the power to approach the NSW government Contract Control Board
to discuss and resolve the issues of "Direct Supply" and "installation only". Through the Government
Contract for Resilient Finishes and report back to the Association at the next General Meeting."
The vote was taken on a show of hands
29 in favour (including proxy votes)
0 Against
The motion was carried.
It was agreed that a sub-committee be formed as resolved in Motion No.3. Messrs.S.Kelly. Kable,
and R.Hooker were nominated to represent the FCA
ARFA will be invited to nominate 3 members and Jason Carter was nominated to act as Chairman and
liaise with the FCA Committee. There was no further General Business.
The meeting closed at 8.45 p.m. |